Dometrics | Manufacturers | Bowman Heat Exchangers

Marine Heat Exchangers

Bowman Marine Heat Exchangers There are three methods employed for water-cooled marine petrol and diesel engines: direct, heat exchanger and keel cooling. Direct cooling of the cylinders and heads by sea-water is unsatisfactory, because the engine - which was probably originally designed for radiator cooling - will run too cold and the sea-water will eventually ruin the cylinder block and heads.

Bowman Heat Exchangers are high-quality products incorporating both the best materials and the latest technical features.

Exhaust Gas Heat Exchangers

Bowman Exhaust Gas Heat Exchangers are designed to remove heat from the exhaust gas of engines and transfer it to the water circuit. These Exhaust Gas Heat Exchangers therefore enable waste heat recovery, and can be used on Cogeneration/Combined Heat and Power (CHP) equipment up to 1 MW.

Header Tank Heat Exchangers

Bowman Header Tank Heat Exchangers were designed originally for marine engines, but they are also widely used for various land based duties, such as engine testing and development work, generator sets, fire pumps and combined heat and power systems (CHP).

Non-Storage Calorifiers

Bowman Non-storage Calorifiers provide a simple method of heating water indirectly from a low pressure primary supply. Because both circuits can be pump assisted the surface area required is only about 25% of that required in conventional storage calorifiers.

Shell and Tube Heat Exchangers

Bowman Shell and Tube Heat Exchangers: are intended for heating or cooling process fluids, they are for example suitable for closed circuit cooling of electrical equipment using dematerialized water and for cooling water soluble oil solutions in quenching tanks.

The shell side usually contains the process fluid and the tube side water from the town mains or a cooling tower, or an ethylene glycol solution from a chiller unit. In certain circumstances this flow arrangement can be reversed, but please consult us first.

Stainless Steel Heat Exchangers

Bowman Stainless Steel Heat Exchangers are particularly useful in bad water environments caused by pollution or from the chemicals used to counter it. They can also be used to overcome the corrosive nature of some synthetic oils and refrigerants.

Inline Plate Heat Exchangers

Bowman In Line Plate Heat Exchangers have been designed as a low-cost alternative to our shell and tube types. They consist of numerous 316 stainless steel heat transfer plates, two outer covers and four connections copper vacuum-brazed together to form an integral unit.

Swimming Pool Heat Exchangers

Bowman is one of the UK's largest manufacturers of Swimming Pool Heat Exchangers. There are two ranges of Bowman Swimming Pool Heat Exchangers, one for use with boilers and the other for use with Solar Panels/Heat Pumps.

Titanium Heat Exchangers

Bowman are pleased to announce the launch of our new range of Titanium Heat Exchangers due to the recognition of an overwhelming market demand. Titanium is an ideal material for Swimming Pool Heat Exchangers as it is impervious to fluctuations in pH levels.

Aquatic Heat Exchangers

Bowman heat exchangers are suitable for use in conjunction with boilers, heat pumps and solar panels for indirect heating of aquatic applications. Bowman units can be supplied with either stainless steel or titanium tube stack and also incorporates the unique features of being able to be dissmantled and cleaned.

Solar Heat Exchangers

These heat exchangers are used in conjunction with solar panels to heat swimming pools. The design of these units allows for the reduced water temperature from solar heating compared with the hotter temperatures from traditional boilers.

Test House Heat Exchangers

These heat exchangers are used in conjunction with solar panels to heat swimming pools. The design of these units allows for the reduced water temperature from solar heating compared with the hotter temperatures from traditional boilers.